Welcome to Scroll Saw Woodworking & Crafts Message Board, an online scroll saw forum community where you can join thousands of scrollers from around the world discussing all things related to Scrolling. To gain full access to the message board you must register for a free account.
As a registered member you will be able to:
* Browse over 200,000 posts.
If you have any problems with the registration process or your account login, please contact the Scroll Saw Woodworking & Crafts Support Team.
| ||LinkBack||Thread Tools||Display Modes|
|10-23-2013, 07:28 PM||#1|
Join Date: Sep 2013
Location: NSW Australia
Thanked 6 Times in 5 Posts
Made this for my son for xmas Ned Kelly was the famous (or infamous) Australian bushranger.Ned made his own armour for himself & his gang & used it at their last stand , Ned was shot in the legs captured & eventually hanged. Size of Ned is 11" x 8" & was taken off a drawing on the net, Cheers Peter
|10-23-2013, 08:30 PM||#2|
Join Date: Jul 2013
Thanked 68 Times in 68 Posts
That is a great looking piece and thanks for the history lesson. It runs in my mind that I have either seen a documentary on Ned or I saw a movie about him.
|10-23-2013, 10:46 PM||#4|
Join Date: Jun 2008
Location: Down on the Corner-Out in the Street
Blog Entries: 9
Thanked 89 Times in 77 Posts
If you have been around the board very long, our old Aussie buddy JohnB told the story of Ned a couple of years back to accompany a cutting he did.
Johns' Post is here
Wonder what the old bloke is up to these days.
"Music takes us places language alone can not"--Glenn Frey
Sawdust on the saw table looks like progress.
Last edited by Jim McDonald; 10-23-2013 at 10:51 PM.
|10-24-2013, 07:56 AM||#5|
there was a movie done years back,and the part of ned kelly was played by none other than MICK JAGGER,lead singer of the rock group the rolling stones,
it was agood movie,exceopt for the bad accents ,the actors tried too put on.
he tried too sound irish ,where jagger is actualy english.
not doing much
and busy doing it
having fun making sawdust.
Last edited by tony coleman; 10-24-2013 at 07:59 AM.
|10-24-2013, 10:39 AM||#6|
Join Date: May 2010
Thanked 32 Times in 30 Posts
Nice cutting Peter - I think you've done a great job of converting a picture to something that can be cut out.
I sorta remember that as well Tony, haven't seen it in years
Experience is something you don't get until just after you need it.