Welcome to Scroll Saw Woodworking & Crafts Message Board, an online scroll saw forum community where you can join thousands of scrollers from around the world discussing all things related to Scrolling. To gain full access to the message board you must register for a free account.
As a registered member you will be able to:
* Browse over 200,000 posts.
If you have any problems with the registration process or your account login, please contact the Scroll Saw Woodworking & Crafts Support Team.
| ||LinkBack||Thread Tools||Display Modes|
|02-07-2010, 03:57 PM||#1|
IM BACK SORTA
Join Date: Sep 2009
Thanked 37 Times in 28 Posts
one for a friend framed
Frame is re-sawed from 1x7 Butternut to aprox 3/8 and routered with a table saw. Sanded to 220 and covered about 5 minutes with Cherry Danish Oil and wiped down.
When the oil is done will most likely coat with the same clear glaze as the portrait.
I HATE FRAMES!!
|02-07-2010, 07:28 PM||#3|
Join Date: Mar 2007
Location: Riverton, KS on Route 66
Thanked 1 Time in 1 Post
Very nicely done Rob. I finally have use of a good table saw, and just purchased a biscuit jointer from Harbor Freight and can do frames better now.
|Thread||Thread Starter||Forum||Replies||Last Post|
|I been FRAMED!!||oily||Off Topic||3||02-25-2012 07:41 AM|
|Framed name puzzles||Markru2002||Scroll Saw Puzzles||4||12-12-2011 12:46 AM|
|Framed Owl Picture||VTScroller||Fretwork and Portraits||9||03-19-2009 10:22 PM|
|Framed||david804||General Scroll Saw||3||10-12-2008 11:50 AM|