New to the site. Need some info - Scroll Saw Woodworking & Crafts Message Board

donhart1966@hughes.net · 10-09-2009, 11:58 PM

Hey everyone. I have been scrolling for about 7 years or so. I don't usually have alot of time to scroll but I recently have alot of time on my hands. I need to know of a good program to make portrait patterns with. I have done a few in the past but I don't have the program to do the transition with anymore. Thank you.

shell7089 · 10-10-2009, 12:39 AM

Gimp is alright there are tutorials with step by step instructions is where I have done a couple at Welcome to the site btw
Shellie

scrollpup · 10-10-2009, 01:37 AM

I'm not any good on those, but welcome to the forums Don.

Jerry

donhart1966@hughes.net · 10-10-2009, 03:29 AM

Thank you Shellie and Jerry.

10-09-2009, 11:58 PM	#1
donhart1966@hughes.net Junior Member Join Date: Oct 2009 Location: Southern Ohio Posts: 2	New to the site. Need some info Hey everyone. I have been scrolling for about 7 years or so. I don't usually have alot of time to scroll but I recently have alot of time on my hands. I need to know of a good program to make portrait patterns with. I have done a few in the past but I don't have the program to do the transition with anymore. Thank you.

10-10-2009, 01:37 AM	#3
scrollpup Avatar by Casey Join Date: Jan 2009 Location: Hot Springs,Arkansas Posts: 1,732	I'm not any good on those, but welcome to the forums Don. Jerry __________________ Two wrongs don't make a right....they just even the score...

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

10-10-2009, 12:39 AM	#2
shell7089 Senior Member Join Date: Sep 2009 Posts: 124	Gimp is alright there are tutorials with step by step instructions is where I have done a couple at Welcome to the site btw Shellie

10-10-2009, 03:29 AM	#4
donhart1966@hughes.net Junior Member Join Date: Oct 2009 Location: Southern Ohio Posts: 2	Thank you Shellie and Jerry.