Need help/info on scroll saw - Scroll Saw Woodworking & Crafts Message Board

SEG 3 · 12-29-2006, 04:29 AM

I am new to this and was recently given a Power Craft scoll saw,sold by the old Monkey Wards by a friend's father. The model no# is 15FD23568. It is an old unit in good shape, runs well an appears to cast iron and heavy, with a large electric motor located underneath the saw. My question is the type of blades this unit should take. I have seen the current blades on the market today "pin style or flat end", which do not fit. This unit appears to take a blade that would require something close to 6 inches long with a size 10 hole thru each end of the blade, to fit the upper an lower shafts that have allen head screw with a bracket that screws into the shaft to hold the blade in place. Our blades available for this saw any longer ? Or does it need to head to the junkyard.

Mick Walker · 12-29-2006, 03:48 PM

SEG3, go to www.scrollsaws.com. Rick may be able to help you.

12-29-2006, 04:29 AM	#1
SEG 3 Junior Member Join Date: Dec 2006 Posts: 1	Need help/info on scroll saw I am new to this and was recently given a Power Craft scoll saw,sold by the old Monkey Wards by a friend's father. The model no# is 15FD23568. It is an old unit in good shape, runs well an appears to cast iron and heavy, with a large electric motor located underneath the saw. My question is the type of blades this unit should take. I have seen the current blades on the market today "pin style or flat end", which do not fit. This unit appears to take a blade that would require something close to 6 inches long with a size 10 hole thru each end of the blade, to fit the upper an lower shafts that have allen head screw with a bracket that screws into the shaft to hold the blade in place. Our blades available for this saw any longer ? Or does it need to head to the junkyard.

12-29-2006, 03:48 PM	#2
Mick Walker Senior Member Join Date: Jan 2005 Location: Janesville, WI Posts: 1,335	SEG3, go to www.scrollsaws.com. Rick may be able to help you. __________________ Mick, - Delta P-20 The future ain't what it used to be.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Anyone with Info/Experience with the Dremel 1800 Scroll Station	mkmmatt1	Beginners Scroll Saw	7	10-18-2007 07:32 PM
Insurance Info	will8989	Off Topic	2	09-20-2006 06:06 PM
Branson MO info	Daryl185	Info Exchange	7	09-10-2006 02:43 AM
Subscription Info	beemerbob	Publisher Feedback	1	07-17-2006 02:49 PM
Thanks for the info	Tomlock	General Scroll Saw	1	03-28-2006 08:58 AM