Need mounting dimensions for DW788 - Scroll Saw Woodworking & Crafts Message Board

RDW43 · 05-19-2005, 04:48 AM

I am designing a stand for the DW788, however mine is in storage 85 miles away. I need to know the measurements for the mounting holes. The distance between centers of the two front holes and the distance to the single back mounting hole. If some has these measurements or can take time to measure your DW788 please Email them to me at rwoods43@netzero.com.

Thank you for your help. Roger

jttheclockman · 05-19-2005, 10:35 PM

There are 3 mounting holes, 2 in the front and 1 in the back in the center. Between the 2 front holes is 9" center to center. Now if you take a straight line between the 2 holes for the front and find center it is 22 1/2" to the back hole which is slotted for a small degree of variable. Hope that helps.

RDW43 · 05-19-2005, 11:30 PM

Thank you John T. That is the dimensions I needed. Will post a photo when I am finished. Roger.

05-19-2005, 04:48 AM	#1
RDW43 Junior Member Join Date: May 2005 Location: Northeast Florida Posts: 2	Need mounting dimensions for DW788 I am designing a stand for the DW788, however mine is in storage 85 miles away. I need to know the measurements for the mounting holes. The distance between centers of the two front holes and the distance to the single back mounting hole. If some has these measurements or can take time to measure your DW788 please Email them to me at rwoods43@netzero.com. Thank you for your help. Roger

05-19-2005, 10:35 PM	#2
jttheclockman Senior Member Join Date: Jan 2004 Location: New Jersey Posts: 743	There are 3 mounting holes, 2 in the front and 1 in the back in the center. Between the 2 front holes is 9" center to center. Now if you take a straight line between the 2 holes for the front and find center it is 22 1/2" to the back hole which is slotted for a small degree of variable. Hope that helps. __________________ John T.

05-19-2005, 11:30 PM	#3
RDW43 Junior Member Join Date: May 2005 Location: Northeast Florida Posts: 2	Thanks Thank you John T. That is the dimensions I needed. Will post a photo when I am finished. Roger.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mounting Question	ScrollIt	Intarsia and Segmentation	19	04-25-2007 03:40 PM
Cutting mats for mounting	PuzzledMoose	Off Topic	3	04-19-2007 08:39 PM
Attachment dimensions	millwab	Message Board FAQ, Suggestions and Feedback	2	10-03-2006 03:26 PM
New Shop Dimensions	MinotBob	General Scroll Saw	29	08-28-2006 05:26 AM
Mounting/Vibration/Carpet Question	Ann	Beginners Scroll Saw	11	01-17-2006 04:00 AM