EX-21 Pick up attachment - Scroll Saw Woodworking & Crafts Message Board

Markru2002 · 08-16-2011, 05:53 PM

hello everyone.
I have an Ex-21 and I wanted to attached my shop-vac hose to pick up the sawdust as I am scrolling. I have already hooked up my footswitch to turn the vacuum on and off with the saw. I see seyco has one, but I was wondering exactly where the hose from the shop-vac sits. I have it under the table sitting where the head tilts but it moves after about 5 minutes of working. I also use the shop-vac to clean the shop so the hose would have to be removable. Any suggestions would be greatly appreciated and pictures would be a bonus. Thanks again for all your help.
Mark

Tom J. · 08-16-2011, 06:56 PM

I don't have a dust collection set up on my EX-21 yet but would look at a hose similar to this one 2-1/2'' FlexForm Dust Collection Hose - Rockler Woodworking Tools
to attach to the saw. The shop vac could then be detached from the hose for other uses.

Tom

08-16-2011, 05:53 PM	#1
Markru2002 Senior Member Join Date: Sep 2010 Location: Southern NJ Posts: 379 Thanks: 16 Thanked 3 Times in 3 Posts	EX-21 Pick up attachment hello everyone. I have an Ex-21 and I wanted to attached my shop-vac hose to pick up the sawdust as I am scrolling. I have already hooked up my footswitch to turn the vacuum on and off with the saw. I see seyco has one, but I was wondering exactly where the hose from the shop-vac sits. I have it under the table sitting where the head tilts but it moves after about 5 minutes of working. I also use the shop-vac to clean the shop so the hose would have to be removable. Any suggestions would be greatly appreciated and pictures would be a bonus. Thanks again for all your help. Mark __________________ Proud new owner of an EX-21 WWW.MGMWOODWORKS.COM

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Help with pattern attachment - PLEASE	Ouch	Beginners Scroll Saw	19	12-27-2011 06:55 PM
Attachment question	azbison	General Scroll Saw	6	04-30-2008 02:53 AM
Pattern attachment Poll	BobD	Publisher Feedback	40	12-18-2007 08:44 PM
Attachment dimensions	millwab	Message Board FAQ, Suggestions and Feedback	2	10-03-2006 02:26 PM
OT: Photo Attachment vs. IMG in Messages	GrayBeard Phil	Message Board FAQ, Suggestions and Feedback	8	05-02-2005 02:33 AM

08-16-2011, 06:56 PM	#2
Tom J. Senior Member Join Date: Oct 2008 Location: Montreal area, Quebec Posts: 303 Thanks: 1 Thanked 3 Times in 3 Posts	I don't have a dust collection set up on my EX-21 yet but would look at a hose similar to this one 2-1/2'' FlexForm Dust Collection Hose - Rockler Woodworking Tools to attach to the saw. The shop vac could then be detached from the hose for other uses. Tom