Did You Ever... - Page 2 - Scroll Saw Woodworking & Crafts Message Board

ffinnell · 06-17-2009, 10:41 PM

I guess that happens to all of us, it was the same when I was working in a machine shop years ago, sometimes a tool would last and last and last, you would feel bad when you finally had to change it and the replacement was never as good. I agree with most though FD blades are great. I first tried the sample pack Mike sells. Also recently tried some new blades offered at Wildwood Designs, it has two forward than a reverse and repeats etc. etc. I found they gave a great finish also. FFinnell "Popi"

BernieT67 · 06-18-2009, 08:41 PM

I just started using Mike's ultras and they are everything he said they would be.
Except (isn't there always an except) about every 4th #3 blade wants to go wwaayy off to the right as soon as I put it in.
I figure it's easier not to argue and just get out a better behaved sister.

Bernie

Wood Dog · 06-19-2009, 01:36 AM

Bernie I find that if a blade wants to go to the right then it is in upside down. Just my observation, but when I flip it then it cuts as is should.

06-19-2009, 01:36 AM	#13
Wood Dog Senior member--Absolutely Join Date: Jul 2007 Location: MA USA Posts: 3,929	Bernie I find that if a blade wants to go to the right then it is in upside down. Just my observation, but when I flip it then it cuts as is should. __________________ WD

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

06-17-2009, 10:41 PM	#11
ffinnell Popi Join Date: Dec 2008 Location: Marion SC Posts: 7	I guess that happens to all of us, it was the same when I was working in a machine shop years ago, sometimes a tool would last and last and last, you would feel bad when you finally had to change it and the replacement was never as good. I agree with most though FD blades are great. I first tried the sample pack Mike sells. Also recently tried some new blades offered at Wildwood Designs, it has two forward than a reverse and repeats etc. etc. I found they gave a great finish also. FFinnell "Popi"

06-18-2009, 08:41 PM	#12
BernieT67 Member Join Date: Mar 2009 Location: lindenhurst IL Posts: 51	I just started using Mike's ultras and they are everything he said they would be. Except (isn't there always an except) about every 4th #3 blade wants to go wwaayy off to the right as soon as I put it in. I figure it's easier not to argue and just get out a better behaved sister. Bernie