Rust prevention for DeWalt and other cast-iron tables.

here's some information Off of a web site I found for a beeswax turpentine formula for the DeWalt scrollsaw and other cast-iron tables this formula worked really well on my old DeWalt and I never had a problem with rust. It also work well with any other cast-iron surface. ------------------------------------------ A Few Things about my DeWALT DW788 Scroll Saw


Copyright 2000 by James P. Riser



This will most likely be the last scroll saw that I ever buy. I love this saw! It is pictured below:



As soon as this saw (or any scroll saw with a cast iron table) is assembled, the table should get its first protection. I wax mine with specially prepared beeswax to prevent rusting and to promote easier sliding of the work piece during cutting.



The beeswax that I use was purchased at an arts and crafts store in the candle department. It came as a flat sheet. It is shown here rolled up for storage. The prepared beeswax is shown in the small container.



To prepare the beeswax I merely broke it into small pieces and placed them in the container. Next I added pure turpentine (not mere thinner!) and mixed it up. After letting things sit for a day or so, the beeswax will form a thick paste wax suitable for putting on your saw table. All I do is spread some of the wax on the table, rub it in, and buff it. One paper towel square does it all. Do not use too much wax. Repeat this wax application as often as you feel it is needed. By the way, such a beeswax preparation is great for using on turned wood (apply it while the item is rotating in the lathe). Below is a closeup of the beeswax mixture to show how thick I make it. If you get yours too thin, just add bees wax.

[Plaquerd]

Red Beard
Thanks for the info. I'll give that a try.
Dave