Square Dance Pattern

[ChuckD]

As I have said a few times before I am a cutter not a designer. But I do need a little help. I am also a square dancer. That is the way I meet my new bride and where I courted her. Also we had a square dance wedding. Anyway I have made a couple of Name plates where folks hang outside thier Camper or motorhome. You know, where they have their name and home town on them. We camp at big square dance festivals. I don't want all of them to be the same and I have used both patterns I have and would like something new. Here are some thumbnails to show you about what I need.
BTW, I don't sell them, they are gifts to friends.

[frieke]

Don't you have a beautiful picture of your wedding or you and your wife in dancing clothes? I could make a pattern and then you have someting very special? Or a pic. just with your heads on? And then little thumbnails of square dancers around it, but just the silhouettes. How big can that name plate be? It's just an idea i have...

[ChuckD]

The "name plate" is a sihlouette of square dance couple, about 14 to 18 inches high, wide enough for their name and state on it. This is a picture of my bride and I with our heads on. As you can see we are not dancing and that is the key.

[frieke]

Hi Chuck,

I made a silhouette of you and your lovely, beautiful bride, what you might use as
name plate. I put your names in it, but that you can hange if you want to.
Now i work on the pattern.

Greetings

[frieke]

Hello Chuck,

Here's the pattern I made for you. I hope you can use it. I would it place it in the silhouette and then you have a very personal name plate. As I understand you would like to make them for others to, is this work for you?
A silhouette of square dancers where you can put there names in?

[frieke]

Hi Chuck,

Here is the final pattern, hope you like it!

[ChuckD]

Frieke, Thank you very much. I have saved both pattterns and they will be cut. however, what I needed is a pattern where you can tell it is silhouette of square Dancers and with room for their names and state. Wish I had a picture of the ones I cut out. BTW, the reason for getting a new one, most of them know each other and go to the sames dance festivals and they shouldn't be alike. This one is for a key holder and would work if I could get it big enough without the keyholder part. Also a couple others, get the idea. Thank you very much

[frieke]

Hi Chuck,
I have send you a PM because i can't upload pics. I'll try again in the morning.

[frieke]

Lucky me, it worked to manage pics.
Hope this is good for you, i resized it, so you can print it out as big as you want.
Please let me know if you want the name plate apart or so?