Pattern problem - Intricate 3-D Christmas Tree - Page 2 - Scroll Saw Woodworking & Crafts Message Board

BobD · 10-20-2010, 08:21 PM

The other pattern was complete....

markdavd · 10-20-2010, 09:21 PM

A word of caution - when you print the corrected pattern and copy the correct side, make sure they are exactly the same size before doing anything. If you look at how the frets line up, any deviation in size will be obvious and could ruin the appearance of the piece.

sawdustus · 10-21-2010, 11:21 AM

Thanks for the correction Bob and the word of caution Mark. I usually copy both parts of a slotted piece and then line them up visually on a light door to make sure the slots and height are the same before cutting them.

george

10-20-2010, 08:21 PM	#11
BobD Technical Editor Join Date: Aug 2004 Location: Lebanon, Pa Posts: 3,386 Blog Entries: 2 Thanks: 10 Thanked 32 Times in 25 Posts	The other pattern was complete.... __________________ www.WoodCarvingIllustrated.com www.FoxChapelPublishing.com www.ScrollSawer.com Shopsmith, Hawk G4

10-21-2010, 11:21 AM	#13
sawdustus Senior Member Join Date: Jun 2006 Location: New Jersey Posts: 3,950 Thanks: 0 Thanked 16 Times in 15 Posts	Thanks for the correction Bob and the word of caution Mark. I usually copy both parts of a slotted piece and then line them up visually on a light door to make sure the slots and height are the same before cutting them. george __________________ A day without sawdust is a day without sunshine. George delta 650, hawk G426

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
More Christmas Tree Ornaments	bdsears	Fretwork and Portraits	15	09-30-2012 03:49 AM
3D Christmas Tree	wsmith0896	Scroll Saw Pattern Requests	1	11-30-2011 10:09 PM
Christmas Tree	JayScot	Scroll Saw Pattern Requests	6	11-23-2011 12:59 AM
Ho Ho Ho Christmas Tree Ornaments	marshall	Fretwork and Portraits	5	11-15-2011 12:32 AM
Angel on top of Christmas tree	Mick Walker	Off Topic	3	12-26-2007 03:12 PM

10-20-2010, 09:21 PM	#12
markdavd Mark Davidson Join Date: Jul 2006 Location: Dallas, Ga Posts: 245 Thanks: 1 Thanked 3 Times in 3 Posts	A word of caution - when you print the corrected pattern and copy the correct side, make sure they are exactly the same size before doing anything. If you look at how the frets line up, any deviation in size will be obvious and could ruin the appearance of the piece.