Article discussion thread:Turning Clipart into Patterns - Scroll Saw Woodworking & Crafts Message Board

articlebot · 11-05-2009, 04:12 AM

This is a dedicated thread for discussing article: Turning Clipart into Patterns

wood-n-things · 11-05-2009, 04:16 AM

Would love to discuss it..but I'm not allowed to read it.
I get this error message here as well

Restricted access.

You don't have sufficient privileges to view this page.

admin · 11-05-2009, 02:22 PM

wood-n-things, you should be able to access that now. Your usergroup (super moderators) had some permissions issues that were fixed.

--Claudio

wood-n-things · 11-05-2009, 03:20 PM

Claudio,
Thanks for addressing this for (us). I was thinking I was doing something wrong..LOL
It works fine now.

Gordie · 11-06-2009, 09:20 PM

Steve's video is so interrupted that I can't follow his instructions. Perhaps someone out there knows a trick

Thanks, Gordie

BobD · 11-06-2009, 09:25 PM

Hi Gordie,
That's probably dependent on your internet speed. I'd start the video, press pause, wait a few minutes until the little grey bar at least halfway across the screen. Then press play. It shouldn't be interrupted anymore.

Bob

11-05-2009, 04:12 AM	#1
articlebot Junior Member Join Date: Aug 2009 Posts: 0	Article discussion thread:Turning Clipart into Patterns This is a dedicated thread for discussing article: Turning Clipart into Patterns

11-05-2009, 04:16 AM	#2
wood-n-things Behave Yourself..I can't. Join Date: Nov 2005 Location: Right here ---silly Posts: 4,471 Blog Entries: 1	Would love to discuss it..but I'm not allowed to read it. I get this error message here as well Restricted access. You don't have sufficient privileges to view this page. __________________ The Mike One of them anyway. Don't be so open-minded. Your brains will fall out!

11-05-2009, 03:20 PM	#4
wood-n-things Behave Yourself..I can't. Join Date: Nov 2005 Location: Right here ---silly Posts: 4,471 Blog Entries: 1	Claudio, Thanks for addressing this for (us). I was thinking I was doing something wrong..LOL It works fine now. __________________ The Mike One of them anyway. Don't be so open-minded. Your brains will fall out!

11-06-2009, 09:25 PM	#6
BobD Technical Editor Join Date: Aug 2004 Location: Lebanon, Pa Posts: 3,051 Blog Entries: 2	Hi Gordie, That's probably dependent on your internet speed. I'd start the video, press pause, wait a few minutes until the little grey bar at least halfway across the screen. Then press play. It shouldn't be interrupted anymore. Bob __________________ www.WoodCarvingIllustrated.com www.FoxChapelPublishing.com www.ScrollSawer.com Shopsmith, Hawk G4

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

11-05-2009, 02:22 PM	#3
admin Administrator Join Date: Dec 2004 Posts: 126 Blog Entries: 4	wood-n-things, you should be able to access that now. Your usergroup (super moderators) had some permissions issues that were fixed. --Claudio

11-06-2009, 09:20 PM	#5
Gordie Member Join Date: Dec 2008 Posts: 32	Steve's video is so interrupted that I can't follow his instructions. Perhaps someone out there knows a trick Thanks, Gordie