Problem with Finishing Forum - Scroll Saw Woodworking & Crafts Message Board

miniwoodworker · 06-16-2009, 09:55 AM

Has the default been changed to show only posts for the last 30 days in the finishing forum? Or is there another problem, as only a few posts are listed and there are no additional page numbers listed.

Anyone else seeing this?

Dragon · 06-16-2009, 01:55 PM

I don't have a problem with that. I think it is a setting in your profile. Go to "userCP" and put in the setting you want.
Diane

BobD · 06-16-2009, 03:27 PM

We did update the forum software, so the default may have changed. I'll ask Claudio to look into it.

BTW, for technical issues like this, it's better to post in the Message Board FAQ section; Claudio is more likely to find a post like this in that section than in the rest of the message board (I moved this post to the Message Board FAQ area).

Bob

admin · 06-16-2009, 04:00 PM

I don't remember changing this setting myself, but I did notice that some of the forums had this setting set differently and very inconsistently. I updated all the forums to show all posts so you should see all the pages.

--claudio

miniwoodworker · 06-17-2009, 06:14 PM

Thanks for the move to the right place and for the fix. Now I see all the pages in Finishing again.

Lee

06-16-2009, 09:55 AM	#1
miniwoodworker Senior Member Join Date: May 2005 Posts: 497	Problem with Finishing Forum Has the default been changed to show only posts for the last 30 days in the finishing forum? Or is there another problem, as only a few posts are listed and there are no additional page numbers listed. Anyone else seeing this? __________________ Lee in NC Als Ik Kan DW788 1975 Dremel (labeled Craftsman) Scroll saw w/3" pin blades

06-16-2009, 01:55 PM	#2
Dragon scroller and moderator Join Date: Dec 2006 Location: Chertsey, Quebec, Canada Posts: 2,421	I don't have a problem with that. I think it is a setting in your profile. Go to "userCP" and put in the setting you want. Diane __________________ Dragon Owner of a Dewalt 788 PuffityDragon on AFSP

06-16-2009, 03:27 PM	#3
BobD Technical Editor Join Date: Aug 2004 Location: Lebanon, Pa Posts: 3,051 Blog Entries: 2	We did update the forum software, so the default may have changed. I'll ask Claudio to look into it. BTW, for technical issues like this, it's better to post in the Message Board FAQ section; Claudio is more likely to find a post like this in that section than in the rest of the message board (I moved this post to the Message Board FAQ area). Bob __________________ www.WoodCarvingIllustrated.com www.FoxChapelPublishing.com www.ScrollSawer.com Shopsmith, Hawk G4

06-17-2009, 06:14 PM	#5
miniwoodworker Senior Member Join Date: May 2005 Posts: 497	Thanks for the move to the right place and for the fix. Now I see all the pages in Finishing again. Lee __________________ Lee in NC Als Ik Kan DW788 1975 Dremel (labeled Craftsman) Scroll saw w/3" pin blades

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

06-16-2009, 04:00 PM	#4
admin Administrator Join Date: Dec 2004 Posts: 126 Blog Entries: 4	I don't remember changing this setting myself, but I did notice that some of the forums had this setting set differently and very inconsistently. I updated all the forums to show all posts so you should see all the pages. --claudio