         | Home Club Search Message Board Scroller Galleries Subscription Services |
Subscribe Today! |
Magazine |
Scroll Saw Community |
Reader's Poll |
Testimonials Fantastic magazine, I love it! I wanted to make sure that I didn't miss an issue. I only wish that it came out more often... Continue |
Found the Fox?  Click here to enter the Fox Hunt contest! |
Welcome to Scroll Saw Woodworking & Crafts Message Board, an online scroll saw forum community where you can join thousands of scrollers from around the world discussing all things related to Scrolling. To gain full access to the message board you must register for a free account.
As a registered member you will be able to:
If you have any problems with the registration process or your account login, please contact the Scroll Saw Woodworking & Crafts Support Team. |
| |||||||
| Register | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
 Info Exchange | |||
 |
| | LinkBack | Thread Tools | Display Modes |
12-10-2006, 12:28 AM
| #1 |
| Senior Member  Join Date: Aug 2006 Location: Georgia, USA
Posts: 819
|  Aligning Odd-shaped cuts I just finished a gift (see my Ga Tech Cutting post in the Bragging Section) that is in the shape of the state of Georgia. I wanted to frame it so aligning it on the backing with symetry was important. I accomplished this by preserving the outer waste material as one piece. I aligned the waste against the backing and slipped the glued cutting into it like one big puzzle piece. I've done the same for small drop-outs by, again, saving the outer piece.
__________________ Mike  Craftsman 16" VS, Puros Indios and Sam Adams! Scrollin' since Jun/2006 My Gallery http://scrollcrafters.com (reciprocal links welcomed) |
|  |
|
12-10-2006, 01:26 AM
| #2 |
| Moderator CUT IT OUT  Join Date: Feb 2005 Location: Chilliwack British Columbia, Canada
Posts: 3,670
| That is an awesome tip Mike thanks for posting it
__________________ CAЯL HIRD-RUTTEЯ "THE LYF SO SHORT, THE CRAFT SO LONG TO LERNE." GUSTAV STICKLEY Ryobi SC180VS scroll saw EX21 |
| |
|
| Thread Tools | |
| Display Modes | |
Linear Mode
| |
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Aligning blade with upper blade holder | sstalker | Info Exchange | 3 | 12-07-2006 04:35 PM |
| Compound Cuts | Ghornet54 | Beginners Scroll Saw | 6 | 11-18-2006 09:27 PM |
| Getting clean cuts | Guest | Beginner | 5 | 09-11-2003 07:08 PM |
| Just a few more cuts | Kenny_S | General Carving | 2 | 09-02-2003 01:06 PM |
| Stop Cuts | whittlinwit | Beginner | 19 | 08-12-2003 01:55 AM |
All times are GMT. The time now is 02:32 PM.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37
