Finger Protectors

[Buzz]

Some place I read where finger protectors were used when sanding. I have found them very useful when cutting the patterns. They seem to give me a more positive feel and control over the wood. I use them on my index and middle fingers of both hands and use my finger tips to control the wood.

[workin for wood]

yea, I think cathy wise uses them. Personally, I like to go for the sandpaper burn once in awhile...keeps me on my toes.

[PeteB]

Interesting...

With the cooler weather my fingers are slightly dry and grip has been a problem, will have to try these out.

Thanks for posting!

Pete

[Dusty Buffalo]

I use a pair of Mechanix gloves.

Although, you have to be careful. I sanded a hole right through the left thumb. It got caught under a piece I was sanding. I didn't actually sand my thumb but put a hole in the glove. The hubby said I needed a new pair. But I figure I still got 9 more fingers to sand through before I have to replace 'em. Besides, I can use duct tape to close up any holes (it is the handyman's secret weapon, ya know)

[Mick Walker]

Buzz, what are these finger protectors made of?

[BobD]

I think they are the little rubber secretary finger tip things you can get cheap at Staples, etc...

I use the vet-wrap that i make custom thumb guards out of when I'm carving...it' easy to use, doesnt' stick, and if I sand through it, I can wrap a few more layers around!

Bob

[earlinjax]

Some people also use that "blue, sticky, wrinkly, tape" (that was a technical term) that medical people use to wrap around bandages. My lab uses it to wrap a piece of cotton on my arm after a blood test. I save it and use it.

EarlinJax

[Buzz]

They are exactly what BobD said they are made of. Rubber with little nodes on them. Mine are called Finger Tips and are made by Swingline. They may take a little getting used to as they are just a little thick, but I have found that I use them all the time. The only time I don't use them is when a part of the paper comes loose and I have to hold it down right next to the blade until I finish the cut. They are too thick to get that close to the blade.
Buzz

[sheltiecarver]

Originally Posted by earlinjax

Some people also use that "blue, sticky, wrinkly, tape" (that was a technical term) that medical people use to wrap around bandages. My lab uses it to wrap a piece of cotton on my arm after a blood test. I save it and use it.

EarlinJax

That stuff is Vetrap if you get it at a feed store, and Koban if you get it (more expensively) at a drug store or medical supply place. I save mine after I donate platelets (about every 2 weeks) If you roll it up without stretching, and keep it in a baggie like a zip-lock, it will last quite a while. I use it while carving sometimes, too. That is a little harder on the tape than scrolling.
Sandy

[owler]

Finger protectors? I kill two birds with one stone. Haven't had to trim my nails in months!