3D mini guitars - Scroll Saw Woodworking & Crafts Message Board

TOUITOUI · 12-08-2008, 12:29 PM

hello from France.
I saw three mini guitars in 3d but I don't remember where on this web site.
Is it a personal creation or I can find this pattern in a book.
thank you very much to help me and to tell me where i can find it.
cordially
Touitoui

CanadianScroller · 12-08-2008, 12:39 PM

there were a few mini guitars
Some were done by Plaquered and some by pialamodem
I think if you check with either of them they could help
The links are to pictures you can search for thier profiles on the forum

Wood Dog · 12-08-2008, 03:25 PM

Touitoui the mini 3D guitars I did were from a pattern from Mike Miklos in issue 21 of Scrollsaw Woodworking & Crafts magazine. I just changed the size of the pattern on my printer to get various sizes. They were fun to do.

TOUITOUI · 12-09-2008, 06:45 AM

It was this pattern.
Thank you for your answer.
I ordered the review at the moment and I'm very exciting to receive it.
Thanks again.
Cordially.
Touitoui

f250 · 12-09-2008, 04:36 PM

I have made a couple of those. My biggest problem in makining these was keeping the blade horizontal and not pushing it off to one side or another. I think my choice of wood was just too hard for the blade size I was using. I need to try again and think a bit more before I jump

Tom

12-08-2008, 12:29 PM	#1
TOUITOUI Senior Member Join Date: Nov 2008 Posts: 104	3D mini guitars hello from France. I saw three mini guitars in 3d but I don't remember where on this web site. Is it a personal creation or I can find this pattern in a book. thank you very much to help me and to tell me where i can find it. cordially Touitoui

12-08-2008, 12:39 PM	#2
CanadianScroller Moderator CUT IT OUT Join Date: Feb 2005 Location: Chilliwack British Columbia, Canada Posts: 3,904 Blog Entries: 12	there were a few mini guitars Some were done by Plaquered and some by pialamodem I think if you check with either of them they could help The links are to pictures you can search for thier profiles on the forum __________________ CAЯL HIRD-RUTTEЯ "proud member of the best scroll sawing forum on the net." Ryobi SC180VS scroll saw EX21

12-09-2008, 04:36 PM	#5
f250 Senior Member Join Date: Sep 2006 Location: Albuquerque Posts: 1,791	I have made a couple of those. My biggest problem in makining these was keeping the blade horizontal and not pushing it off to one side or another. I think my choice of wood was just too hard for the blade size I was using. I need to try again and think a bit more before I jump Tom __________________ Hawk G4 http://www.scrollsawer.com/gallery/s...00/ppuser/4243

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

12-09-2008, 06:45 AM	#4
TOUITOUI Senior Member Join Date: Nov 2008 Posts: 104	It was this pattern. Thank you for your answer. I ordered the review at the moment and I'm very exciting to receive it. Thanks again. Cordially. Touitoui