Warren handle used with Flexcut unhandled gouges - Scroll Saw Woodworking & Crafts Message Board

01-12-2004, 08:27 PM

Does anybody know if the Flexcut unhandled gouges will work with the warren handle?

01-12-2004, 10:03 PM

don't know about the warren, am sure someone like Rick at little shavers can tell you. I have the flexcut bits for a ryobi and bought the flexcut handle for them.

01-13-2004, 04:33 AM

don't think they will unless you get some kind of an adapter

01-13-2004, 01:58 PM

No they dont but you can purchase a flexcut handle to accomadate those chisels for less than $20.00 works just fine.
Colin

01-12-2004, 08:27 PM	#1
Guest Guest Posts: n/a	Warren handle used with Flexcut unhandled gouges Does anybody know if the Flexcut unhandled gouges will work with the warren handle?

01-12-2004, 10:03 PM	#2
Hi_Ho_Sliver Guest Posts: n/a	Re: Warren handle used with Flexcut unhandled goug don't know about the warren, am sure someone like Rick at little shavers can tell you. I have the flexcut bits for a ryobi and bought the flexcut handle for them.

01-13-2004, 04:33 AM	#3
big_wayne_p Guest Posts: n/a	Re: Warren handle used with Flexcut unhandled goug don't think they will unless you get some kind of an adapter

01-13-2004, 01:58 PM	#4
colin_partridge Guest Posts: n/a	Re: Warren handle used with Flexcut unhandled goug No they dont but you can purchase a flexcut handle to accomadate those chisels for less than $20.00 works just fine. Colin

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
warren cutlery	macktruck	General Carving	1	02-28-2004 11:32 PM
Broom Handle	macktruck	Tools and Blades	8	12-31-2003 04:29 PM
Flexcut Gold	muffy	Wood Finishing and Painting	4	04-04-2003 10:38 PM
Warren Tools?	Rando	Off Topic	6	09-29-2002 02:28 AM
Flexcut tools??	Guest	Off Topic	2	02-20-2002 12:48 AM