Welcome to Scroll Saw Woodworking & Crafts Message Board, an online scroll saw forum community where you can join thousands of scrollers from around the world discussing all things related to Scrolling. To gain full access to the message board you must register for a free account.
As a registered member you will be able to:
* Browse over 200,000 posts.
If you have any problems with the registration process or your account login, please contact the Scroll Saw Woodworking & Crafts Support Team.
|Fretwork and Portraits|
| ||LinkBack||Thread Tools||Display Modes|
|07-23-2014, 09:04 PM||#1|
Join Date: Dec 2007
Location: Mentor, Ohio
Thanked 113 Times in 91 Posts
This is a Steve Good Pattern and it is about 14 inches tall. The corian I used was a sink cutout from a kitchen install. The corian is 1/2 inches thick. I used a #9 ultra Reverse blade to cut the pattern.
|07-24-2014, 01:00 AM||#2|
Join Date: Aug 2010
Location: Tucson, AZ
Blog Entries: 1
Thanked 146 Times in 114 Posts
you sure are fast. I just got that pattern this morning. Good job!
Pacifism is great, as long as everyone is participating.
The Southern Arizona Woodturners Association
Desert Woodcrafters woodworking club
Grandpa for the 7 most amazing children.
|07-24-2014, 01:21 PM||#4|
Join Date: Nov 2008
Thanked 18 Times in 17 Posts
And you can wipe it off with a damp cloth! Nice cutting, you must have a good dust pick up system.
|07-24-2014, 08:56 PM||#5|
scroll saw newbie
Join Date: Dec 2013
Location: Alta Loma, CA
Thanked 10 Times in 10 Posts
Downloaded the pattern too...gotta find the right piece of wood for this one...
"tongue-tied and twisted, just an earthbound misfit...I"----pf
|07-24-2014, 09:48 PM||#6|
Join Date: Jun 2007
Location: MA USA
Thanked 154 Times in 139 Posts
Sweeeeet cut DW, did you get any melting? Or does Corion not melt when cutting?
WD aka: Gloria
" Two memorable things to say in life are Hello for the first time and Good-by for the last".
|07-24-2014, 10:05 PM||#7|
Join Date: Dec 2009
Location: Barnesville, GA *Buggytown*
Thanked 4 Times in 4 Posts
nice looking job on the cat DW, i second the remark about you being fast
wood dog, you have to cut corian at a slower pace to keep it from melting, unless you have the resin based corian….there are at least 2 types that i know of…acrylic based, which will melt back together if cut too fast or slow, and the resin based, the waste turns to powder, instead of clumping like the acrylic based
when i cut corian, i stack cut one type of each together, that way there’s not much melting going on for me
"Celebrate what you ACCOMPLISH, but raise the bar each time you SUCCEED” …… Mia Hamm
|07-24-2014, 10:10 PM||#8|
Join Date: Mar 2011
Thanked 17 Times in 17 Posts
That is awesome!
"It's not what you look at that matters, it's what you see."
Henry David Thoreau