First try at portrait - Page 2 - Scroll Saw Woodworking & Crafts Message Board

jamescroller · 07-24-2009, 06:04 PM

hi daddy d c,
i use a spray on varnish on my potraits,and i prefer matt rather than gloss..

Daddy Daycare · 07-24-2009, 11:49 PM

Here is a cutting I did today. I was up late last night learning how to use Gimp and I cut it out today. I am in love with spiral blades all of a sudden. But it's probably just young love. I need to get a very find drill bit. 1/16 doesn't seem to be small enough.

I think I've gotten better in the week I've been at it.

scrollpup · 07-25-2009, 04:39 PM

Great job on all the portraits DD! you done good on GIMP also. I like Mikes mini drill bits just to give ya an input on where to buy some.I don't know where you buy blades from,but you can get his and the drill bits for the same shipping cost.

Jerry

07-25-2009, 04:39 PM	#13
scrollpup Avatar by Casey Join Date: Jan 2009 Location: Hot Springs,Arkansas Posts: 1,926	Great job on all the portraits DD! you done good on GIMP also. I like Mikes mini drill bits just to give ya an input on where to buy some.I don't know where you buy blades from,but you can get his and the drill bits for the same shipping cost. Jerry __________________ Work your fingers to the bone, and what do you get? Boney fingers.....Boney fingers.....

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

07-24-2009, 06:04 PM	#11
jamescroller Junior Member Join Date: Jul 2009 Posts: 15	hi daddy d c, i use a spray on varnish on my potraits,and i prefer matt rather than gloss..