Welcome to Scroll Saw Woodworking & Crafts Message Board, an online scroll saw forum community where you can join thousands of scrollers from around the world discussing all things related to Scrolling. To gain full access to the message board you must register for a free account.
As a registered member you will be able to:
* Browse over 200,000 posts.
If you have any problems with the registration process or your account login, please contact the Scroll Saw Woodworking & Crafts Support Team.
| ||LinkBack||Thread Tools||Display Modes|
|05-22-2014, 08:22 PM||#1|
Join Date: Dec 2007
Location: Mentor, Ohio
Thanked 129 Times in 106 Posts
Skittles Tower - Proof of Concept
This is an adaptation of Steve Goods Gum Ball dispenser and a jelly bean dispenser I recently saw on the boards. The skittles drop from the wheel hole and hit 3 sloped ramps to end up in the pull out tray. It will dispense Skittles, M&M's ( all makes ) Reeses Pieces, 1/2 gumballs and small shelled nuts.
The dispenser has been cut from pine and poplar. It is 18 inches tall and 7 inches at the base plate. It was finished with tung oil only. This is the proof of concept build. I wanted to see if it would work out.
|05-22-2014, 09:54 PM||#2|
sarcastic old geezer
Join Date: Aug 2010
Location: Tucson, AZ
Blog Entries: 1
Thanked 166 Times in 133 Posts
That's super DW!
Pacifism is great, as long as everyone is participating.
The Southern Arizona Woodturners Association
2015 President of The Desert Wood crafters woodworking club
Grandpa for the 7 most amazing children.
|05-26-2014, 11:01 PM||#4|
Laying into Inlay
Join Date: Feb 2007
Location: Lincoln, RI
Thanked 24 Times in 23 Posts