Welcome to Scroll Saw Woodworking & Crafts Message Board, an online scroll saw forum community where you can join thousands of scrollers from around the world discussing all things related to Scrolling. To gain full access to the message board you must register for a free account.
As a registered member you will be able to:
* Browse over 200,000 posts.
If you have any problems with the registration process or your account login, please contact the Scroll Saw Woodworking & Crafts Support Team.
| ||LinkBack||Thread Tools||Display Modes|
|11-25-2011, 07:48 PM||#1|
trying to be good
Join Date: Jul 2011
Thanked 0 Times in 0 Posts
Heip with box
Ok so I wanted to gett rid of end grain showing on side of boxs,So I gluded up some 3/4 by 2" in a square with conters at 45%. then cut it round. I s there any other way to this? If you don't have 2" wood. Lance
|11-25-2011, 11:11 PM||#2|
Join Date: Dec 2007
Location: Mentor, Ohio
Thanked 129 Times in 106 Posts
You would need to make a raft that was all end grain. Cut your board into 1 inch wide strips. The top and bottom get glued together leaving the end grain exposed. Cut your bowl from this glue up and you should have no end grain showing on the sides only the bottom of the bowl.