Pinned to Pinless - Scroll Saw Woodworking & Crafts Message Board

Dallas · 12-28-2005, 12:45 PM

Here is a question that I need help with. I have a Wilton scroll saw that uses 5 inch pinned blades. Is there an device that I can change out that would allow me to use pinless blades? I know the head comes off so that is the part I think I need to change.

Any advice would be greatly appreciated.

CanadianScroller · 12-28-2005, 12:50 PM

There is a source out there, Pozsgai's Designs.
They have several adapter for different scroll saws.
If you contact them I am sure they can help.

12-28-2005, 12:45 PM	#1
Dallas Junior Member Join Date: Jul 2005 Location: Monticello, Minnesota Posts: 6 Thanks: 0 Thanked 0 Times in 0 Posts	Pinned to Pinless Here is a question that I need help with. I have a Wilton scroll saw that uses 5 inch pinned blades. Is there an device that I can change out that would allow me to use pinless blades? I know the head comes off so that is the part I think I need to change. Any advice would be greatly appreciated.

12-28-2005, 12:50 PM	#2
CanadianScroller Moderator CUT IT OUT Join Date: Feb 2005 Location: Chilliwack British Columbia, Canada Posts: 3,695 Blog Entries: 13 Thanks: 0 Thanked 3 Times in 2 Posts	Pin to pinless There is a source out there, Pozsgai's Designs. They have several adapter for different scroll saws. If you contact them I am sure they can help. __________________ CAЯL HIRD-RUTTEЯ "proud member of the best scroll sawing forum on the net." Ryobi SC180VS scroll saw EX21

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Pinless blades and Mothers Day	cpowell	Beginners Scroll Saw	13	12-31-2012 04:56 PM
I hate pinless blades	cpowell	Beginners Scroll Saw	17	05-11-2012 12:41 PM
pinless blades in my old craftsman?	SteveA	Tools and Blades	4	11-10-2010 11:45 AM
Pinned/Pinless and the Hitachi CW40	IgnatiusJReilly	Beginners Scroll Saw	11	05-07-2009 12:25 AM
pinned or pinless?	Shawn Rogers	General Scroll Saw	9	01-09-2007 02:16 AM